Categories

CONTACT US

Hongchao(Dongguan)Mold & Technology Co.,Ltd.
Mobile:18925597988
Tel:86 0769-82621066
Fax:86 0769-82621099
Website: http://www.injection-mould-cn.com
E-mail:sales@injection-mould-cn.com
Address:tangxia Town,Dongguan City,Lincun,New 16

Current Location:Home -->FAQ


causes and solutions for part shots

If too little plastic injection molding material flows into the mold, the cavity will not fill properly, which we refer to as part shots. This can be corrected by changing the plastic injection molding parameters. If it is because the blockage in flow at the feedthroat, the barrel temperature in the rear should be decreased. If the melt material is too high in viscosity, then the injection rate and process temperature should be increased. And the gate and runner size should be increased.
【Clicks:】 【Joined:2013-04-28】 【Close this page

Address: Tangxia Town, Dongguan city, the 16th, new Sun City Tel: 0769-85337367 fax: 0769-85337367

Copyright © 2006-2011HongChao Mold Steel,INC E-mail:sales@injection-mould-cn.com